Care And Maintenance; Cleaning And Storage; Troubleshooting; Service Information - DeWalt DXAEC10 Instruction Manual

Charger for 6 volt/12 volt lead-acid batteries & 12v lithium batteries
Table of Contents

Advertisement

Available languages

Available languages

Care and Maintenance

CLEANING AND STORAGE

To reduce the risk of electric shock, unplug the battery charger from
the outlet before attempting any maintenance or cleaning. Turning off
the controls will not reduce this risk.
• Store the unit in a clean, dry, cool place when not in use.
• Never submerge this unit in water. Dirt and grease may be removed
from the exterior of the unit using a cloth or soft non-metallic brush.
Never let any liquid get inside the unit; never immerse any part of
the unit into a liquid.
• To maintain the operating condition and maximize the life of the
charger cords, always coil them loosely for storage. Do not wrap
them around the unit or crimp them with a tight band.
CAUTION: TO REDUCE THE RISK OF INJURY OR
PROPERTY DAMAGE: Ensure that unit is completely
disconnected from battery and power source before cleaning.
Turning off controls will not reduce this risk.

Troubleshooting

Problem
Possible Solution
Unit not charging
• Check that the charger is properly
connected to a live AC outlet.
• Check that the correct voltage setting
has been selected for the battery being
charged.
• The charger may overheat. Disconnect
the connections. Allow the charger to
cool down for a period. Ensure there are
adequate ventilation around the charger
before attempting to charge again.
• If the battery to be charged has fallen
below 2 volts, the battery cannot be
recharged with this unit.
Accessories
WARNING: Since accessories, other than those offered by
D
WALT, have not been tested with this product, use of such
e
accessories with this unit could be hazardous. To reduce the risk of
injury, only D
WALT recommended accessories should be used with
e
this product.
If you need assistance regarding accessories, please contact the
manufacturer at 1-888-394-3392 or CustomerService@dewalt12volt.
com.

Service Information

Whether you need technical advice, repair, or genuine factory
replacement parts, contact the manufacturer at 1-888-394-3392 or
CustomerService@dewalt12volt.com.
14

Advertisement

Table of Contents
loading

Table of Contents