Husqvarna 120iTK4-H Operator's Manual page 12

Battery
WARNING:
safety chapter before you use the battery.
Read and understand the operator's manual
for the battery and the battery charger.
Keep the battery and the battery charger in the correct
ambient temperatures.
Ambient temperature
Operation of the battery 5 °C-40 °C / 41 °F-104 °F
LED indicator
4 LED lights are on
3 LED lights are on
2 LED lights are on
1 LED light is on
1 LED light flashes
To charge the battery
Charge the battery if it is the first time that you use it. A
new battery is only 30% charged.
CAUTION:
Connect the battery charger
to a power outlet with the voltage and
frequency that is specified on the rating
plate.
The battery does not charge if the battery temperature is
more than 50 °C/122 °F.
1. Connect the power cord to the battery charger.
2. Connect the battery charger to a grounded power
outlet. The charging LED flashes one time. (Fig. 34)
3. Connect the battery to the battery charger. The
charging LED comes on. Charge the battery for
maximum 24 hours. (Fig. 35)
4. Push the battery indicator button, if all the LED
indicators come on, the battery is fully charged.
5. Pull the power plug to disconnect the battery charger
from the power outlet. Do not pull the power cord.
6. Remove the battery from the battery charger.
To connect the battery to the product
WARNING:
original batteries in the product.
12
Read and understand the
Battery status (state of charge)
BLi10
N/A
The battery is 76% - 100% charged.
The battery is 51% - 75% charged.
The battery is 26% - 50% charged.
The battery is 0% - 25% charged.
Only use Husqvarna
Ambient temperature
Charging of the battery 5 °C-40 °C / 41 °F-104 °F
Battery status
The display shows the state of charge and if there are
problems with the battery.
(Fig. 33)
40-B70
The battery is 76% - 100% charg-
ed.
The battery is 51% - 75% charged.
The battery is 26% - 50% charged.
The battery is 6% - 25% charged.
The battery is 0% - 5% charged.
1. Make sure that the battery is fully charged.
2. Put the battery into the battery holder of the product.
The battery must move into the holder easily, if not, it
is not installed correctly. (Fig. 36)
3. Push the lower part of the battery and push it in fully
into the battery holder. The battery locks into position
when you hear a click.
4. Make sure that the latches lock in position correctly.
To start the product
1. Push and hold the start/stop button until the green
LED comes on. (Fig. 37)
2. Pull the power trigger lockout rearward and hold the
power trigger.
To operate the product
• Start near the ground and move the product up
along the hedge when you cut the sides. (Fig. 38)
• Hold the product near your body for a stable work
position. (Fig. 39)
• Make sure that the tip of the cutting equipment does
not touch the ground.
• Be careful and work slowly until all the branches are
correctly cut.
To adjust the angle of the cutting attachment
The cutting attachment can be adjusted in 7 different
positions.
1. Stop the product and remove the battery. (Fig. 40)
1553 - 008 - 31.10.2022