Table of Contents
Advertisement
ALLPLEX Access Easy Master Controller
Follow the instructions below on using IP Setup to retrieve the configured IP settings.
1.
2.
Figure 4.2 Interface of IP Setup program
NOTICE!
IP Setup will only find controllers in the same network segment as the PC. For example, if the
IP address of the PC is 129.2.0.1 with subnetmask 255.255.0.0, IP Setup only scans for
controllers with the IP address ranging from 129.2.0.1 to 129.255.255.
3.
Figure 4.3 IP Setup starts scanning
4.
Figure 4.4 Results of the scan
5.
For more information on other functionalities of IP Setup, please refer to Section 5 Using IP
Setup of the Utilities Program Manual.
Robert Bosch (SEA) Pte Ltd
Double-click the IPSetup icon to launch the IP Setup program.
Click Start menu item, or the Start button from the right pane to start scanning the
controllers for their IP settings.
IP Setup begins to scan for controllers within the network.
Results of the scan are displayed in the window.
Using the MAC address information from the label on the ALLPLEX AEMC, match the
MAC address from the scan results to find the corresponding IP address.
Quick Installation Guide
Installation of ALLPLEX AEMC | en
F.01U.251.137 | V1.0.0 | 2011.08
11
Advertisement
Table of Contents
