Table of Contents
Advertisement
13.
Put Setup Date Label to the place that you notice easily such as system case.
14.
Install the side cover on the server. Connect power cord to the receptacles to
recover the original state and power on the system.
15.
To confirm whether the RAID Controller is recognized from system after OS
started. In detail, refer to [2-2. Checking by Utility].
URU may not able to recognize the battery pack if it is charged only at the minimum
level (or uncharged). If this occurs, charge the battery pack for six hours or longer.
Then reboot the server and try to recognize the battery pack again by using URU.
Notice
The battery pack is recyclable. To inquire about it , contact your service
representative or bring it to the nearest recycle agent.
Tips
Location to connect LED cable
1 pin
2 pin
42
Advertisement
Table of Contents
