Table of Contents
Advertisement
Cancelling the delay start
after the countdown has
started
To cancel the delay start:
1. Touch the Delay Start
repeatedly until the display shows the
desired delay time. On the display
the indicator shows
Touch the Start/Pause
appliance lock the door and starts the
countdown of the delay start. The display
shows the indicator
When the countdown is completed, the
programme starts automatically.
2. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
3. Touch the Delay Start
repeatedly until the display shows
and the indicator
4. Touch the Start/Pause
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pause
again to start the new countdown.
12.8 The AutoAdjust System
load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start/Pause
button, the maximum declared load
indicator goes off, the AutoAdjust System
starts the laundry load detection:
button
button. The
.
button to
button
goes off.
button
button to
button
button
1. The appliance detects the load in the
first 30 seconds. In the programmes
where Flexitime is available, during
this phase the Flexitime bars
placed below the time digits play a
simple animation. The drum rotates
shortly.
2. The programme duration could be
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause
the programme again. The AutoAdjust
phase can be repeated up to three times
(see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The AutoAdjust detection is
carried out with complete
washing programmes only
and if the programme
duration has not been
reduced by means of the
Flexitime button.
The AutoAdjust System is
not available with all
programmes such as :Wool/
Silk, Rinse and programmes
with short cycles.
ENGLISH
23
is
button to start
Advertisement
Table of Contents
