Table of Contents
Advertisement
3. Turn the turnbuckle clockwise to lower the height
of cut and counterclockwise to raise it until you
reach the desired setting on the height-of-cut gauge
(Figure 2).
Height-of-cut Position
(Height in Inches)
1/2
1
1-1/2
2
2-1/2
3
3-1/2
4
4-1/2
5
5-1/2
4. Set the turnbuckle lock to lock the height-of-cut
setting in place.
Adjusting the Anti-scalp Skids
1. Park the machine on a flat level surface, stop the
engine, and wait for all moving parts to stop.
2. Loosen the two bolts and nuts securing an anti-scalp
skid and raise or lower it so that they are lower than
the blades but not touching the ground (Figure 3).
1. Height of cut
3. Tighten the bolts and nuts.
4. Repeat this procedure for the other side using the
same measurement you set in step 2.
Height of Cut (mm)
13 mm
25 mm
38 mm
51 mm
64 mm
76 mm
89 mm
102 mm
114 mm
127 mm
140 mm
Figure 3
2. Anti-scalp skid
5
Advertisement
Table of Contents
