Counter Terminal
Connecting Shielded Lines via the Shield Connector
A
1 5 m m
( 0 . 5 9 " )
C
E
DOK-CONTRL-R-IL*CNT***-AW02-EN-P
Mounting and Dismounting Counter Terminals / Connecting Lines
a
F
Fig. 4-8: Connecting the shield on the shielded connector
Shielded lines must be used exclusively when you are connecting sensors
at the 5 V counter input and at the 5 V control input. Connection at the 5 V
counter input is described here. This input must be wired as follows in
accordance to the connector assignment in chapter "Assignment of
Terminal Points" on page 1-5:
Proceed as follows (compare Fig. 4-8) :
Counter input 5 V
GND counter input
Shield
B
8 m m
( 0 . 3 1 " )
D
F 2
F 1
Connector 2
Terminal point 1.1
Connector 1
Terminal point 1.3
Connector 1
Shield connection
4-7
5 9 7 9 0 0 0 5
59790005.eps