Table of Contents
Advertisement
3 Get started
Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
laser exposure or other unsafe operation.
Always follow the instructions in this chapter
in sequence. If you contact Philips, you will
be asked for the model and serial number of
your apparatus. The model number and serial
number are on the bottom of your apparatus.
Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
•
Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
To insert the remote control battery:
1
Open the battery compartment.
Insert the supplied AAA battery with
2
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Connect power
The unit can be powered by either AC power
or batteries.
Option 1: AC power
Warning
•
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back or the underside of the unit.
•
Risk of electric shock! When you disconnect the AC
power, always pull the plug from the socket. Never
pull the cord.
Connect the AC power cord to:
AC~ MAINS
the
•
•
the wall socket.
Tip
•
To save energy, turn the unit off after use.
Option 2: Battery power
Caution
•
Batteries contain chemical substances, so they should
be disposed of properly.
Note
•
Batteries are not supplied with the unit.
1
Open the battery compartment.
Insert 6 batteries (type: R-20 or D CELL)
2
with correct polarity (+/-) as indicated.
3
Close the battery compartment.
socket on the unit.
EN
7
Advertisement
Table of Contents
