Table of Contents
Advertisement
SETTING UP THE VCR
•
Cable TV searches for cable channels
•
Antenna searches for local broadcast stations
•
Detect Automatically will make this decision for you
The VCR begins scanning for the available channels—this
takes about one to two minutes. When the scan is complete,
the VCR tunes to the lowest channel number. At this point,
pressing CHAN up or down on the remote control or VCR
should only select the active channels.
To Change the Signal Type
1. Press MENU to display the VCR MAIN MENU.
2. Press 4 to display the CHANNELS menu.
CHANNELS
1 Auto Channel Search
2 Add/Remove Channels
3 Signal Type:
4 VCR Plus+ Channel List
5 Cable Box Setup
0 Exit
3. Press 3 to change the Signal Type between CABLE and
ANTENNA.
Adding or Removing Channels
You may want to add or r emove channels after you Auto
Channel S earch, especially if some of the channels have weak
signals or you don' t want to watch them.
1. Press MENU to display the VCR MAIN MENU.
2. Press 4 to display the CHANNELS menu.
3. Press 2 to display the ADD/REMOVE CHANNELS screen. Use
the CHAN up or down keys on the remote or number
buttons to go to the channels you want to remove or add.
ADD/REMOVE CHANNELS
Channel 115
is presently ADDED
Press CLEAR to remove
Press MENU to exit
10
CABLE
ADD/REMOVE CHANNELS
Channel 115
is presently REMOVED
Press INFO to add
Press MENU to exit
Selecting Channels
The Channel up and down buttons
access those channels active in
your VCR channel list.
You can still access channels not
on the channel list by using the
number buttons on the remote
control.
Advertisement
Table of Contents
