Advertisement

Quick Links

Safety instructions.........................2
Operating instructions ...............3
Automatic Thermostat .................................3
Controls ............................................................3
Cleaning...........................................................3
Light Bulb Replacement...............................3
GE Appliances
36'
Installation ............................................4-6
Damper/Duct Connector .,..........................4
Filter Panel .......................................................5
Mounting Brackets ........................................5
Electrical Wiring .............................................6
Consumer Services.....................7
important Phone Numbers..........................7
I

Advertisement

Table of Contents
loading

Summary of Contents for GE JV694

  • Page 1: Table Of Contents

    36’ Installation ..........4-6 Safety instructions......2 Damper/Duct Connector .,......4 Filter Panel ............5 Mounting Brackets ........5 Operating instructions ....3 Electrical Wiring ..........6 Automatic Thermostat .........3 Controls ............3 Consumer Services.....7 important Phone Numbers......7 Cleaning............3 Light Bulb Replacement.......3 GE Appliances...
  • Page 2: Safety Instructions

    EVACUATE AND (%LL THE FIRE ‘ DEPARTMENT. Must Be l)cms By Qwdii%d Person(s) In Aceordauce UNLY and exhausting of gases through the flue and you already know how to operate it. (chimney) of i%el-burning equipment to prevent 2. The fire is small aud confied in the area manufacturer’s guideline and safety standards where it started.
  • Page 3: Operating Instructions

    OPERATING INSTRUCTIONS Always turn your hood on before you begin cooking to establish an air flow in the kitchen. Let the hood run for a few minutes to clean the air after you turn the range off. This will keep the whole kitchen cleaner. Controls hood is “OFF”...
  • Page 4: Installation

    INSTALL THE HOOD PLAN THE IHSTALLATIOH new hood will fit a standard 36” wide flush 1. Mark and cut-out the cabinet bottom. Your bottom or recessed bottom, framed or frameless CABINET kitchen cabinet which has a minimum depth of CENTER CABINET back wall.
  • Page 5: Filter Panel

    5. Remove the access cover. 7. Install the mounting brackets. OLE) Hold the left hand mounting bracket in place on “the side of the housing as shown. 6. Open the filter panel. #S-18 (WIT (2) sets of screws are provided. Use the short screws for flush bottom cabinets or long screws for recessed bottom cabinets.
  • Page 6: Electrical Wiring

    8. Secure the hood to the cabinet+ CAUTION: DO NOT CONNECT POWER AT THE SERVICE ENTRANCE AT THIS TIME. PLASTICCAP #8-18 xl12° 13. Install the glass drawer assembly. Align the hood with the sides and front edge of the cabinet. Tighten the screws in each mounting bracket.
  • Page 7: Consumer Services

    We’ll Be There With the purchase of your new GE appliance, receive the assurance that ifyou ever need AGE consumer service professional will provide expert repair service, scheduled at a time that’s convenient for you. Many GE Consumer Service company-operated locations offer you service today or tomorrow, or at your convenience (7:00 a.m.
  • Page 8 Attorney General. Warrantor: General Electric Company If further help is needed concerning this warranty, write: Manager-Consumer Affairs, GE Appliances, Louisville, KY 40225 JV694 Part No. 164D2588P265 Printed in the United St&...

This manual is also suitable for:

Jv695

Table of Contents