Table of Contents
Advertisement
Cleaning and Maintenance
After cleaning, install in the order as shown in the figure below
a. Align the roller brush with the hole and insert;
b. Put the belt on the gear position of the roller brush;
c. Install the protective cover;
d. Use a coin to lock the floor brush buckle according to the direction shown in the figure.
Groove
Roller brush
Hole
Buckle
Raised
Open
Protective cover
Groove
1. When there is garbage accumulated in the air path of the floor brush, please remove it
with disposable chopsticks;
2. When the filter part of the floor brush is full of dust, please remove with flat nozzle;
3. Do not wash with water except for the rotating part and the cover (or else it will cause
malfunction);
4. Do not inject oil on both ends of the rotating part (or else it may cause poor rotation).
Filter part
Flat nozzle
Air path
Belt
Gear
Roller brush
Groove
Close
Disposable chopstick
Cleaning and Maintenance
Other Cleaning
Main unit
Wipe with a dry cloth. Please remove the garbage attached to the
main unit with the provided cleaning brush.
Extension tube
Wipe with a dry cloth.
Round brush, flat nozzle
Wash and dry.
Advertisement
Table of Contents
