Channelview Channel Listings; Photos And Moving Video As Composite Video - Mitsubishi Electric WD-65738 Basic Owner's Manual

ChannelView Channel Listings

ChannelView displays program descriptions sent by
broadcasters. This information may be unavailable
in some areas.
About ChannelView
ChannelView™ shows memorized channels on the ANT
input. It displays channel names and program information
for digital channels. No program information is displayed
for analog channels.
ChannelView allows you to set up three banks of custom
channels for convenient access. You can save groups of
channels by content (e.g., news, sports, children's program-
ming) or by TV user.
Note: You must first set the TV Clock (page 24) to
receive ChannelView listings.
ChannelView, "All" tab. Programs for the tuned channel
are listed on the right.
ChannelView Custom Channel Banks
Select a channel bank to customize.
1.
Press GUIDE to display ChannelView.
2.
Press MENU to move the highlight to the bank
header.
3.
Press to select Bank 1, 2, or 3.
4.
With the bank name highlighted, press
enter setup mode where you can select channels to
include in the bank.
5.
EXIT when finished with setup.
Press
Using Custom Channel Banks
• While watching TV, press
tune only to channels stored in the current bank.
• To change to a different channel bank:
1. Press GUIDE.
2. Press MENU.
ENTER to
CH
/ . The TV will
3. TV Features
3. Press to highlight a bank.
4. Press MENU to see channels in the bank.
• To allow tuning to any channel in memory, select
the All bank.
Photos and Moving Video as
Composite Video
Note: 838 series TVs can display photos and play mu-
sic from a USB drive. See the detailed owner's
guide at www.mitsubishi-tv.com.
Connect the camera to the TV using a composite video
cable and control the slide show or movie through the
camera. The display resolution will be standard-defini-
tion (480i).
1.
Refer to the owner's manual supplied with the
camera for instructions needed for this setup.
2.
Set the camera's output signal type to
put the camera into playback mode.
3.
With the camera still turned on, connect your digital
camera's composite video cable (usually yellow) to
the TV's Y/VIDEO jack. To hear audio, connect the
camera's audio output cable to the AUDIO L jack.
INPUT 3
AUDIO AUDIO
Pr Pb Y/ VIDEO Y/ VIDEO L L
Camera connection using a composite video cable
4.
When the New Device Found screen displays,
assign the name Camcorder.
5.
Press EXIT to close the New Device Found screen.
6.
Highlight the icon for the camera input and press
ENTER.
7.
If viewing photos, control the slideshow from the
camera. Advance through the images manually or
check if the camera can advance automatically.
For assistance call 1(800) 332-2119
15
NTSC and
USB HDMI 4
R
Optional
Audio Cable