Table of Contents
Advertisement
BEFORE OPERATION
PRINT PAPER INSTALLATION
The paper tray adjusts to the size of the paper you are installing. Do not force paper
that is too long or too wide into the tray.
•
Use only the tray designed for this printer.
•
A spacer for protection during transport is attached inside the paper tray
when the printer is shipped from the factory. Remove this spacer when using
the printer.
1 Pull down the plate lever of the paper tray until it clicks into the
1
1
1
1
lock position.
2
2 If necessary, adjust the paper tray to fit the paper you are
2
2
2
installing.
Move the paper width adjuster and paper length adjuster according to the paper size
you are installing. Move them as shown below.
paper size
Paper width adjuster
A4
Raise
Letter long
Lay down
3
3 Take the print paper out of the packaging together with the
3
3
3
protection sheet.
•
The paper may be stuck together. Loosen the pages well before unpacking.
•
The cardboard is placed on the top of the print paper to protect the printing
surface. Take the cardboard together with print paper so that you do not
touch the printing surface.
4
4
4 Place the paper in the paper tray with the protection sheet on
4
4
top.
Make sure that the front corners of the stack are under the metal tabs.
NOTE
Paper length adjuster
Raise
Lay down
NOTE
Plate lever
Paper width
Paper length adjuster
adjuster
Loosen the paper
before unpacking.
Tab
12
Advertisement
Table of Contents
