Mix Outputs; Selecting Aux/Sub Group, Pre/Post Fade, Send Point Etc - Yamaha M7CL-48 Quick Start Manual

Mix outputs; selecting aux/sub group, pre/post fade, send point etc.

There are 16 mix bus outputs available in addition to the matrix, master and monitor outputs.
The mix buses can be configured as variable auxes or fixed sub-groups.
By default, the 16 mix buses are all variable (auxiliaries). The first 12 are pre fade sends (monitor) and the last
4 are post fade (effects), but these can all be changed individually.
Change individual sends.
To change a mix group from variable (aux) to fixed (sub-group), or to change the variable send point from prefader
to pre-EQ/dynamics, access the BUS SETUP pop-up from the SETUP page. Configure mixes as stereo here too.
MTAC STUDIO M7CL Quick Start Guide - FOR TRAINING PURPOSES
To change mixes pre/
post, press on a knob
image to get the MIX
SEND popup
14
Press for output routing,
insert, EQ or Dynamics
popups.
Use encoders below to
adjust sends from mix
groups into matrix.
Route to Stereo and pan
from here (only if
needed).
Change whole mixes.