Motorola DCT5100 Setup Manual page 6

Connecting the DCT5100 to a High-Definition TV – Video Only
TO
TV/VCR
Cable/
Antenna IN
This diagram shows the High-Definition video
connection between your Motorola DCT5100
and your High-Definition television (HDTV).
This is the primary diagram for providing
HD video and should be done prior to the
following audio configurations.
HPNA
IR
CABLE
USB
IN
HDTV
Video 1 Video 2
Video 3
Y
S-Video
Pb
Video
Pr
R R R
Audio
L L L
Connector cables to be used:
• 6 ft coaxial cable
• Three-pronged component video cable
1. Using a coaxial cable, connect cable wall outlet to the CABLE IN coaxial input on the DCT5100.
2. Locate the Y Pb Pr inputs on your HDTV and the Y Pb Pr outputs on the DCT5100.
To make identification easy, these connecters are color-coded on the DCT5100
(Y = green, Pb = blue, and Pr = red). Colors may vary on your HDTV.
3. Using a three-jack component video connector, connect the Y output on the DCT5100
to the Y input on your HDTV. Do the same for the Pb and Pr connections.
AUDIO IN VIDEO
R L SPDIF IN OUT
S-VIDEO
TV
Pass Card
R L
Y Pb Pr
AUDIO
OPTICAL
OUT
SPDIF
DCT5100
IEEE 1394
SWITCHED
105/125V
60Hz
4A MAX
CONVENIENCE
500W MAX
OUTLET
Do not plug the DCT5100 power cord into a wall
outlet until you have completed all connections
between the DCT and other components.