Table of Contents
Advertisement
COMPRESSOR INSTALLATION - ASSEMBLY
NOTE: The connections on the compressor must be kept
blanked off during installation. The refrigerator oil in the
compressor is highly hygroscopic.
Mount the bracket for the compressor - Although the parts
are different for the basic models, they are sufficiently simi-
lar to require only one set of instructions.
1. Remove the alternator and its adjuster. Refer to Fig 68.
2. Remove the screws of the rear engine mount on the right
side of the machine. Refer to Fig 68.
3. Fix the mounting bracket to the engine using the new screws
supplied. T4240 mounting is shown in Fig 69.
Bolt new mounting over engine mount using new bolts.
Refer to Fig 69.
4. Use longer bolt supplied to fix the alternator and mounting
bracket to existing alternator mounting lug on the engine.
Refer to Fig 70.
5. Bolt the additional pulley for the compressor to the existing
engine crankshaft pulley. Refer to Fig 70.
6. Fit alternator adjuster strap. Refer to Fig 71 (A).
7. Fit compressor. Refer to Fig 71 (B).
8. Fit compressor adjuster strap. Refer to Fig 71 (C).
9. Refit existing alternator drive belt but do not tension. Refer
to Fig 71 (D).
10. Fit new compressor drive belt but do not tension. Refer to
Fig 71 (E).
Issued: 01.04.11
Approved:
Fig 68
Fig 69
Fig 70
Fig 71
Mod. No.
5060358
(C)
(E)
(D)
Sheet 52 of 64
Part No. 111-4431 (A)
(B)
(A)
Advertisement
Table of Contents
