Advertisement
For using Touch Panel
1. Turn off the monitor.
2. Install the equipment.
- Using slot 2 type PC (OPS):
Connect the slot 2 type PC into the option board slot. Connect the B type connector
to the USB upstream port on the left back side of the monitor and the A type
connector to the downstream port on the slot 2 type PC.
NOTE: Please refer to the slot 2 type PC's manual for connection.
NOTE: When you set option board accessory other than slot 2 type
PC, touch function may not work.
- Using external computer:
Connect the B type connector to the USB upstream port on the left back side of the
monitor and the A type connector to the downstream port on the external computer
(Figure 1).
NOTE: On all ShadowSense touch displays from 40" up to 80", the USB connector
type B is located on the left back side of the monitor, above the OPS slot. (Figure 2)
NOTE: On all ShadowSense touch displays from 84" up to 98", the USB connector is
located on the bottom of the right back side of the monitor. (Figure 3)
Figure 1:
2
© NEC Corporation 2016
*1
Figure 2:
Advertisement
