NEC MultiSync LT280 User Manual page 8

1. Preparing User Supportware 3
Important
• You can use the Desktop Control Utility 1.0 to operate a personal computer located in a
separate room from the projector over a network. Therefore, care must be exercised to
prevent any third party from viewing the screen of your personal computer (important
documents), copying files, or turning off the power.
NEC assumes no liability for any loss or damages arising from information leak or system
failure while you are using Desktop Control Utility 1.0.
• In the Windows operating system, click [Control Panel] → [Performance and Maintenance]
→ [Power Options] → [System Standby] → [Never]. This will disconnect LAN connection
when the personal computer goes in the standby mode while the Desktop Control Utility
1.0 is being used.
• The screen saver function is off while Desktop Control Utility 1.0 is running.
I Ulead Photo Explorer 8.0 SE Basic
Ulead Photo Explorer 8.0 SE Basic (hereafter referred to as "Ulead Photo Explorer 8.0") is a
multimedia image file management tool developed by Ulead Systems, Inc. This tool has functions
to capture images from a digital camera or scanner and to process or edit images, as well as
image file management functions. In addition, slideshows and screen savers can also be easily
created.
G Ulead Photo Explorer 8.0 in the User Supportware 3 CD-ROM has functions that allow you
to use the projector more conveniently, in addition to the functions that come with the software,
for when an NEC projector is connected.
Additional functions are listed below.
For details of each function, refer to the help function of Ulead Photo Explorer 8.0.
• • • • •
Image transmission
Sends images to the projector.
• • • • •
PowerPoint file conversion
Converts a PowerPoint file into an image file.
• • • • •
Logo transfer
Registers an image file as the logo data of the projector.
• • • • •
Capture
Saves the screens of the personal computer as image files.
• • • • •
Slideshow start
Sends the image of a slideshow to the projector and executes the slideshow on the
projector.
• • • • •
Viewer output
Converts a slideshow into an index file that can be played back by the viewer function of
the projector and outputs the index file.
8
( page 37)