Temperature Control; Light Mode; Control Lock; Usb Output Charges - GE PRV02 Owner's Manual & Installation Instructions

Operation

Temperature Control

• When a zone is selected, Press
setting.
• The default temperature setting for 50L model is 5°C/41°F.
• The default temperature setting for 75L model is 5°C/41°F for RIGHT ZONE, -18°C/-0.0°F for
LEFT ZONE.
• Each time the
• To display the cooler's current temperature, press and hold the
simultaneously for 3 seconds. While the temperature display is flashing, press the
button to switch the temperature display to F or C. If no key is pressed for 5 seconds, the
temperature setting display will stop flashing and display the current temperature.
• The Temperature range setting from -6°F ~ 68°F. (-21°C~+20°C).

Light Mode

• Press Light mode button to activate and enter light setting mode.
• Light mode: toggle through High, Mid and Low.
• Low:
5 seconds goes to SLEEP
any button betouched again.
• Mid:
brightness. After 20 seconds, the display goes into SLEEP
light at low brightness until any button is pressed
• High:

Control Lock

• Press and hold Control Lock button for 3 seconds to lock or unlock the control. When the
control lock is activated, all buttons are disabled.
• Once the Control Lock is selected, press any button, the Control Lock
flash to indicate the control is locked.
• When the power is turned off or if there is a sudden loss of power, the control lock function
will retain its previous setting when power is restored.

USB Output Charges

Door switch and Light

• The sensor on the light board detects whether the door is open or closed and will turn the
light on or off.
10
or
or is pressed, the temperature setting will change 1°C/°F.
button to increase or decrease the temperature
and button
and
49-1000674 Rev. 4