Advertisement
Precautions with regard to safety
Warning
Wait until the lamp is cooled sufficiently before replacing the lamp unit.
The lamp cover gets very hot, and contact with it can cause burns.
Make sure that all four lamp units are installed.
Do not remove any screws (such as the black screws) other than those indicated when
replacing the lamp unit.
If this is not observed, electric shocks, burns or other injuries may occur.
Do not disassemble the lamp unit.
If the lamp section breaks, it may cause injury.
Replace of the lamp unit should be carried out by a qualified technician.
Notes on replacing the lamp unit
Be careful when handling a light source lamp. The lamp unit has high internal pressure. If improperly handled,
failure might result.
A used lamp unit may burst if it is handled violently. For disposition of used lamps, request an industrial waste
disposal contractor.
If you continue to use a lamp after the replacement time, the lamp may break.
Phillips screwdriver is necessary when replacing a lamp unit. Take care not to slip your hand when using a
screwdriver.
Grip the handle when you remove the lamp unit. Some parts of the lamp unit are sharpened and may cause
injury.
NOTICE
For USA only
Hg-LAMP CONTAINS MERCURY, Manage in Accord with Disposal Laws,
See: www.lamprecycle.org or 1-888-411-1996
2 - ENGLISH
Advertisement
