Table of Contents
Advertisement
G e t t i n g
I n i t i a l
S t a r t e d
S i t e P r o
STEP 5:
PROGRAM THE
CONTROL SYSTEM
Once the control system and hydraulic
system have been defined, you can set
up irrigation programs.
Name the irrigation program and
select a percent adjustment (if
desired) (Setup > Programs)
Select the schedule mode for the
program (Setup > Programs >
Schedule)
Choose from 14-day Calendar,
Interval, Odd Days, Even Days or Annual Calendar.
Assign the active days for the program (Setup > Programs > Active Days)
Set the active days if either the 14-Day Calendar or Annual Calendar mode has been
selected. Once set, the active days on the calendar turn bright green.
Specify ET parameters and run-time calculation (Setup > Programs > ET Use)
Specify the run-time calculation method of the program, ET mode, source of ET,
reference ET and default run times.
Assign repeats and soaks (Setup > Programs > Repeats/Soaks)
Select the number of repeats of the selected program and specify the minimum soak
time for stations in the program.
Assign auto switches (Setup > Programs > Auto Switch)
Assign switches using the Auto Switch tab.
Review program setup (Setup > Programs > Summary)
Verify the feature settings and configuration of each of your irrigation programs.
Create master program sequences (Setup > Programs > Start Times > Information)
Start times are assigned to master program sequences. Go to the Information tab under
Programs > Start Times to create and name a master sequence.
Assign programs to master sequences (Setup > Programs > Start Times >
System Programs)
Assign programs to specific master sequences. All programs in the system are listed.
Define master sequence attributes and program modes (Setup > Programs >
Start Times > Information)
• Highlight a sequence and assign it a watering priority, percent adjustment and a start
or stop time.
• Select a program and choose a running mode: normal or syringe/test cycle.
• Click on the check box to make the program part of the master sequence.
11
Assign stations and review station assignment (Setup > Assign Stations)
Use the table on the Assign Stations screen to assign stations to a particular program or
select Auto Programmer to create assignments. Review stations assignments here.
16
SitePro Central Control System
M a n u a l
S e t u p
—
through
—
11
Advertisement
Table of Contents
