Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine. Fender Support tube Assemble the fenders. Flange-head capscrew (5/16 x 1-3/4 inches) Flange locknut (5/16 inch) –...
Page 3
Drilling the Axle Frame Tube No Parts Required Procedure g282354 Figure 1 1. Flange-head capscrew 3. Support tube g284106 (5/16 x 1-3/4 inches) Figure 2 2. Bracket (fender) 4. Flange locknut (5/16 inch) 1. Holes (axle frame tube) Assemble the other support tube to the other If your machine does not have holes in the axle frame fender bracket with 2 flange-head capscrews tube...
Page 4
g284107 Figure 4 1. 11 mm (7/16 inch) drill bit g284109 Figure 3 Drill the centerpunch marks with a 11 mm (7/16 1. 51 mm (2 inches) 3. 44.5 mmm (1-3/4 inches) inch) drill bit (Figure 4) through both walls of the tube.
Page 5
Torque the nuts and bolts to 1978 to 2542 N∙m (175 to 225 in-lb). Repeat steps through for the fender at the other side of the machine. Installing the Fenders onto the Machine Parts needed for this procedure: Capscrew (5/16 x 4 inches) Washer (5/16 inch) Flange locknut (5/16 inch) Procedure...