Entering And Leaving The Trap; Adjusting The Rake Angle; Adjusting The Trowels - Toro Sand Pro 3040 Operator's Manual

of the trap almost to the end, turn to either direction as
sharp as you can, and come right back next to the first
pass. Spiral outward as shown in the drawing, and
leave the trap at a right angle in a level area.
Leave steep, short banks and small pockets for
touch-up with a hand rake.
1. Enter a trap straight into
the long dimension in a
level area.
Entering and Leaving the
Trap
When entering the trap, do not lower the rake until the
rake is over the sand. This avoids cutting the turf or
dragging grass clippings or other debris into the trap.
Lower the rake while the machine is moving.
When leaving the trap, start raising the rake when the
front wheel leaves the trap. As the machine moves
out, the rake lifts and does not drag sand out onto
the grass.
You will soon gain, through experience and practice,
the required timing for entering and leaving the trap
properly.

Adjusting the Rake Angle

You can change the position of the rake to increase
or decrease its aggressiveness in the sand. Mount
the drawbar and the rake as shown in the following
figures to attain the desired aggressiveness.
Figure 9
2. Exit a trap at a right angle
in a level area.
Setting the Least Amount of Tine
Engagement
1. Flat on top
2. Drawbar
1. Mount the hitch assembly so that the flat side is
on top (Figure
2. Assemble the drawbar to the underside of the
hanger assembly
g003409
Setting the Maximum Amount of
Tine Engagement
1. Angled on top
2. Drawbar
1. Mount the hitch assembly so that the angled
side is on top
2. Assemble the drawbar to the top side of the
hanger assembly

Adjusting the Trowels

You can adjust the length of the trowels to increase or
decrease the amount of prong penetration.
9
Figure 10
3. Rake
10).
(Figure 10).
Figure 11
3. Rake
(Figure 11).
(Figure 11).
g262217
g262218