Advertisement
SS-NA8ES
2-4.
LOUDSPEAKER (1.9 cm) (ASSIST TWEETER) (SP3, SP4)
Note 1: When exchanging the loudspeaker (1.9 cm) (assist tweeter) (SP3, SP4),
refer to "NOTE THE SPEAKER UNITS REPLACING" on page 2
2 two screws (BV B3.5
Note 3: When tightening screws, be
careful not to put the wire of
loudspeakers.
Note 4: Check that the screw has not
floated or it is not slanting.
Note 5: Check that packing (C) has
not overflowed the edge of
loudspeakers.
Note 6: tightening torque:
5 loudspeaker (1.9 cm)
(assist tweeter:
upper side) (SP3)
3 Lift up the loudspeaker
(1.9 cm) (assist tweeter:
upper side) (SP3).
4 packing (C)
stand
loudspeaker (1.9 cm) (assist tweeter: upper side)
(SP3)
Note 9: When disassembling loudspeakers (1.9 cm) (assist tweeter)
(SP3, SP4), be sure to perform the polar check of "+" and
shown in the following figure.
"+"
loudspeaker (1.9 cm) (assist tweeter: lower side)
(SP4)
Note 10: Check that the connection mistake or insertion of a wire are not imperfect.
Note 11: Insert the terminal straightly.
Note 12: The arrangement of a wire should check that left side is gray and that right side is black.
Note 13: Check that a wire is on a speaker (2.5 cm) assy (SP5).
6
10)
2 two screws (BV B3.5
Note 3: When tightening screws, be
careful not to put the wire of
loudspeakers.
Note 4: Check that the screw has not
floated or it is not slanting.
Note 5: Check that packing (C) has
not overflowed the edge of
loudspeakers.
Note 6: tightening torque:
1 terminal
(black)
1 terminal
(gray)
Note 7: Do not touch the
convex part.
stand
–
"–"
10)
Note 8: Check packing (C) not having
–
5 loudspeaker (1.9 cm)
(assist tweeter:
lower side) (SP4)
3 Lift up the loudspeaker
(1.9 cm) (assist tweeter:
lower side) (SP4).
4 packing (C)
speaker (2.5 cm) assy
(SP5)
tweeter assy
Note 2: When disassembling loudspeakers
convex
part
–
–
overlapped or not having run
aground.
–
packing (C)
boss
packing (C)
boss
(1.9 cm) (assist tweeter) (SP3, SP4),
place a stand etc. under tweeter assy
and be careful not to crush the convex
part of a speaker (2.5 cm) assy (SP5).
speaker (2.5 cm) assy
(SP5)
loudspeaker (1.9 cm)
(assist tweeter:
upper side) (SP3)
"–" wire (black)
loudspeaker (1.9 cm)
(assist tweeter:
lower side) (SP4)
"+" wire (gray)
–
Advertisement
