Maintenance - Husqvarna S 13 Operator's Manual

Hide thumbs Also See for S 13:
Table of Contents

Advertisement

Available languages

Available languages

The filter must be cleaned from time to time. This
must be done before changing the plastic bag collection
system and should also be done when work is
completed or when there is poor suction.
1. While running the dust extractor, seal the inlet using
the inlet plug or the inlet valve.
2. Let the dust extractor build up vacuum for 5
seconds, then quickly push and hold down the Jet
Pulse handle for 5 seconds.
Introduction
WARNING:
equipment, refer to
equipment on page 6 , during service. Dust
can be exposed during maintenance and
service.
WARNING:
machines occur during trouble shooting,
service and maintenance as staff have to
locate themselves within the risk area of the
machine. Prevent accidents by being alert
and by planning and preparing the work.

Maintenance

Look for signs of wear,
damage or loose connec-
tions of the controls before
the unit is connected.
Do a check that the Longo-
pac is correct.
Do a check of the filter
cleaning mechanism.
Do a check of the dust
hose and the connections.
Do a check of the wheels.
Look for damage and bad
connections.
Clean the pre-filter.
Replace the pre-filter.
Replace the HEPA filter
To clean the dust extractor
It is important to clean the dust extractor to prevent
circulation of dangerous dust. Always clean the dust
extractor before it is moved from the work area.
896 - 005 - 01.12.2022
Maintenance
Use personal safety
Personal protective
Most accidents involving
Before each
Daily
use
X
X
X
X
3. Repeat step 2 five times. It is important to let the
dust extractor rebuild the vacuum in between every
repetition.
4. If suction remains poor, the filter should be replaced.
Only replace plastic bag after cleaning the filter.
WARNING:
switched off during operations described in
this chapter unless otherwise stated.
WARNING:
components should only be performed by a
licensed electrician.
Maintenance schedule S - Line Dust
Extractor
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
Weekly
When suc-
tion is low
X
X
X
X
WARNING:
its OFF position and disconnect the cord
from the wall outlet before you clean or do
maintenance to the product.
The motor should be
All checks involving electric
6 months or
12 months
1000h
or 2000h
X
X
Turn the motor switch to
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S 26S 36

Table of Contents