Solution Setup Checklist - Lenovo ThinkSystem DW612S System Configuration Manual

Figure 9. Enclosure label on the front of the enclosure
Table 6. Enclosure label on the front of the enclosure
Enclosure label
1

Solution setup checklist

Use the solution setup checklist to ensure that you have performed all tasks that are required to set up your
solution.
The solution setup procedure varies depending on the configuration of the solution when it was delivered. In
some cases, the solution is fully configured and you just need to connect the solution to the network and an
AC power source, and then you can power on the solution. In other cases, the solution needs to have
hardware options installed, requires hardware and firmware configuration, and requires an operating system
to be installed.
The following steps describe the general procedure for setting up a solution.
Setup the solution hardware
Complete the following procedures to setup the solution hardware.
1. Unpack the solution package. See
2. Install any required hardware or solution options. See the related topics in "Hardware replacement
procedures" in User Guide or Hardware Maintenance Guide.
3. Connect all external cables to the solution. See
connectors locations.
Typically, you will need to connect the following cables:
• Connect solution to the power source
• Connect solution to the data network
• Connect the solution to the storage device
• Connect the solution to the management network
ThinkSystem DW612S Neptune DWC Enclosure System Configuration Guide
22
"Solution package contents" on page
Chapter 2 "Enclosure components" on page 9
21.
for