Summary of Contents for Mitsubishi Electric PAC-SNH11HB-E
Page 1
Compatib ble with uni its: PUHZ PUHZ PUHZ NOWHO OOD BA ACK KI PUHZ 1, P100 PTIONA AL PAR 1, P100 AC-SNH H11HB- stallati on Man nual afety Pr recautio • Please read these precaution ns for your safety befo ore installat tion.
Page 2
sembly emble the snow hood d by follow wing the st eps in the assembly manual pr rovided aft er checking g all mponents ar re available Componen In a addition to this installa ation manu al, please c check the f following co omponents are include...
Page 3
To p prevent the t thermistor wire from being damaged durin installatio Pane el, attach the e wire to wire guard using the Tie B Band as show wn in the diagr ram. Ensure band is secu then remove exce ess.
Page 4
1 Mount L Pan nel using temporary m mounting point. L Panel is mou unted betwee n rear panel a and wire guar d, take care n not to twist gu uard wire whe en tightening s screws. After bottom t two screws ha ave been mou unted, tighten...
Page 5
Mount R Panel using emporary mo unting point. 2 Use mountin ng screws to m mount R Panel l to unit. After r bottom two s screws have been mounte ed, tighten the e top tempora ary mounting screw to secu ure R Panel.
Page 6
Remove existing screws from Top Panel. 3 Align slots on CT Panel with temporary mounting points on L and R Panels. Once the hole has been marked With CT Panel in position, align the holes on the CT remove the CT Panel.
Page 7
Using d d rill screw cre eate mounting hole in positi ion that has b been marked. Discard drill l screw after r one use. Remou unt CT Panel u using existing mounting scr rews and scre w provided.
Page 8
ghten screws in temporary mounting pos sition. gular Chec cks/Mainte enance Plea ase check t he followin g items reg gularly for s safety: Check if th ere is no lo oose screw on the sno ow hood an nd in the jo ints betwee...