MANUAL [SINGLE] STATION OPERATION
1. From the default screen (press ESC twice to reach screen if not in it), press the Right Arrow Key on
the controller keypad until OPERATIONS is displayed in the screen.
2. Press the Down Arrow Key until Manual is displayed in the screen
3. Press the Enter Key to view the Manual Operations screen.
4. Press the Up Arrow Key to display the Station that you want.
5. Press the ON/YES Key to turn the displayed station on.
6. The default manual time is 30 minutes. If a different time is desired: Press the Right Arrow Key and
enter the desired runtime using the numeric keypad.
7. Press ENTER Key to set new manual runtime.
8. To turn the station off, press the OFF/NO Key.
9. Press the ESC Key twice to return to Default screen.
MANUAL PROGRAM OPERATION
Note: Sentinel Controllers have 16 Programs. These Programs are divided into 4 Groups
(Clusters A, B, C, & D) with 4 Programs, each. Program Designation follows the following
Format: Cluster X, Program Y = CXPY where X can be A, B, C, or D and Y can be 1-4.
CAP1
CAP2
CAP3
CAP4
1
2
3
4
1. From the default screen (press ESC twice to reach screen if not in it), press the Right Arrow Key on
the controller keypad until OPERATIONS is displayed in the screen.
2. Press the Down Arrow Key until Auto Slot / Station is displayed in the screen.
3. Press the Enter Key to view the Auto Slot / Station Screen.
4. Press the CLUSTER / SCHEDULE SELECT Key and the PROGRAM SELECT Key to choose the Cluster
and Program # to start.
5. Press the ON/YES Key to turn the displayed program on. Note: The program will start at the top of
the next minute.
6. To turn the program off, press the OFF/NO Key.
7. Press the ESC Key twice to return to Default screen.
SENTINEL SATELLITE QUICK REFERENCE
CBP1
CBP2
CBP3
CBP4
5
6
7
8
CCP1
CCP2
CCP3
CCP4
9
10
11
12
CDP1
CDP2
CDP3
CDP4
13
14
15
16
Page 6 /8