Installing A Camera Directly To An Indoor Wall; Installation Requirements; Preparing The Wall For Installation; Installing The Wall Mount - Bosch AUTODOME IP starlight 5000i Installation Manual

AUTODOME IP starlight 5000i (pendant)
7

Installing a Camera Directly to an Indoor Wall

7.1

Installation Requirements

–
–
7.2

Preparing the Wall for Installation

Notice!
i
Indoor use only!
The instructions in this chapter apply to indoor installation only. For outdoor installation, use
either the surveillance cabinet (NDA-U-PA x ) or the mount plate (NDA-U-WMP).
1.
2.
3.
4.
5.
7.3

Installing the Wall Mount

1.
2.
Make sure that the cables are long enough to reach through the mount and the mounting cap
of the camera to the connections from the camera.
1.
2.
3.
7.4

Attaching the Mounting Cap and the Camera

1.
2.
3.
Bosch Security Systems
The wall is thick enough to install the mounting screws.
The wall can sustain at least eight (8) times the weight of the camera (1.88 kg (4.14 lb)):
> 15 kg (33 lb).
Determine a secure location for the wall mount. Ensure there is an adequate opening in
the wall for the cables to pass through.
Use the direct connect plate as a template to mark the location to drill holes for the four
mounting screws (and anchors (user-supplied) if necessary), and to cut the hole for the
cables.
Drill the holes.
Insert the wall anchors (user-supplied) (if necessary) into the wall at the locations
marked in step 2.
Cut an appropriately-sized hole for the cables, using a drywall utility saw or jig saw.
Attach the direct connect plate to the wall.
Thread the RJ45 cable and 24 VAC cables through the wall and then through the
(adapter).
Slide the mounting flange over the wall mount.
Attach the wall mount to the mounting flange and to the direct connect plate using four
M5 screws.
Attach the wall mount to the mounting flange and fix them on the front door of the Wall-
mount Surveillance Cabinet by using four M5 screws.
To make a watertight seal, wrap PTFE tape () four times around the threads at the end of
the mount.
Attach the mounting cap to the mount.
Secure the locking screw with the T15 Torx screwdriver.
Installing a Camera Directly to an Indoor Wall | en
Installation Manual
2023-02 | 1.4 | F.01U.413.551
19