O Return To On-Line Data State; P Select Pulse Dialling; Q Result Code Suppression; S0 Automatic Answer - Nokia 6090 Command Manual

O Return to On-Line Data State

P Select Pulse Dialling

Q Result Code Suppression

S0 Automatic Answer

S1 Ring Count

Nokia 6090 AT Command Set
This command is used when you have made a connection with the remote device
and have escaped (with the +++ command) to the command mode. Give the
command to return from the (on-line) command mode to normal on-line operation.
(V.25ter)
Syntax:
ATO[<n>]
Result Codes
Possible verbose Numeric
result codes (V1) (V0)
CONNECT 1
CONNECT 1200 5
CONNECT 2400 10
CONNECT 4800 11
CONNECT 9600 12
ERROR 4
NO CARRIER 3
OK 0
This setting is ignored. It is included for compatibility reasons. (V.25ter)
Syntax:
ATP
This command determines whether responses are sent to the DTE or not. Affects
only result codes, not information responses. (V.25ter)
Syntax:
ATQ[0]
ATQ1
Value indicates number of rings (RING or +CRING result codes) to wait before
answering automatically. Value 0 disables auto-answer. (V.25ter)
Syntax:
ATS0=<n>
ATS0?
Returns number of rings (RING or +CRING result codes) counted after last MT call
setup. (De facto.)
Syntax:
ATS1?
Go to on-line state. Response is
CONNECT [<speed>].
Description
data/fax call established; rate 300 bps (or X
forbids rate display)
data/fax call established; rate 1200 bps
data/fax call established; rate 2400 bps
data/fax call established; rate 4800 bps
data/fax call established; rate 9600 bps
command cannot be actioned
call could not be established
command aborted
Enable sending of responses to DTE.
Default option.
Disable sending of responses to DTE
Values for <n> are 0..255 (default 0).
Query current setting.
Response is <n>.
Query current setting.
Response is <n>. Values for <n> are
000..255.
61