Advertisement
Functions
9.
Once the set cook time has elapsed, the slow cooker will beep five times to indicate
that the cooking cycle is complete.
10. If no inputs are made after one minute, the slow cooker will automatically enter in
the Warm function for 4 hours. After the automatic Warm time has elapsed, the slow
cooker will go into standby.
SERVING
1.
Place warmed food into the ceramic vessel. Foods can be heated and cooked in the
slow cooker using one of the cooking functions (High, Med, Low, or Soup) and then
left in the slow cooker on either the Warm or Buffet setting. Alternatively, foods can be
heated in a microwave oven, stove top, or oven and then placed into the slow cooker.
NOTE: The warm and Buffet settings are for serving and keeping already cooked and
heated foods warm. It should not be used to cook food.
NOTE: Do not place hot items into a cool ceramic vessel as this may cause it to crack.
2.
Plug the unit into a proper electrical outlet. The control panel will light up, beep, and
then show four dashes to indicate that the unit is in stand-by.
3.
Press the Warm or Buffet button to select the desired serving function. The Buffet
setting will provide a slightly higher temperature than Warm so select the setting that
best suits your needs.
4.
The default time for the selected serving function will be displayed. Pressing the Cook
Time button will increase the time by 30 minute intervals. Once the maximum time
is reached, the time will cycle back and start at 30 minutes. Pressing and holding the
Cook Time button will scroll through the time at a faster rate.
5.
Once the desired time has been selected, push the On/Off button to begin the serving
function. The timer will begin counting down in one minute increments.
6.
During the Warm or Buffet cycle, the time may be increased by pressing the Cook Time
button. The time will increase from the current time to the next 30 minute interval and
then it will increase in 30 minute intervals each time the Cook Time button is pressed.
7.
During the Warm or Buffet cycle, the function cannot be changed. To change the
function, press the On/Off button and then select the desired function. Adjust the time
as needed and press the On/Off button to begin the function.
8.
Once the set time has elapsed, the slow cooker will beep five times to indicate that the
cycle is complete and then go into standby mode.
EN
7
Advertisement
