Download Print this page

General Information; Warnings & Safety Rules; Features; Specifications - ABB H-CK 400 Operating Instructions Manual

Hydraulic compression tool

Advertisement

1.0
1.1
WARNINGS & SAFETY RULES
WARNINGS
1. BE FAMILIAR WITH YOUR TOOL.
Read the instruction manual. Become aware of its
proper usage as well as the potential hazards.
2. NEVER ATTEMPT TO MAKE A COMPRESSION ON A
"HOT" LINE. HIGH VOLTAGE!
• Never assume the power is OFF! Determine
beforehand if any electrical hazards could exist when
making a connection to a line or wire.
• Tools are NOT insulated for use on or near energized
conductors. Use of these tools near energized
conductors may lead to electrical shock, causing
severe injury or death. DO NOT use these tools near
energized conductors without adequately protecting
operator and surroundings.
3. KEEP FINGERS AND OTHER BODY PARTS AWAY
FROM COMPRESSION DIES & MOVING PARTS.
Pinch point hazard. Compression Dies at high force can
cause severe personal injury. Keep all body parts away
from moving parts of the tool during operation.
4. WEAR ALL REQUIRED PERSONAL PROTECTIVE
EQUIPMENT.
5. DO NOT DISPOSE OF TOOL OR BATTERY AS
RESIDUAL WASTE. TOOL CONTAINS HYDRAULIC
OIL, AND OTHER COMPONENTS WHICH MUST BE
DISPOSED OF SEPARATELY ACCORDING TO
LOCAL ENVIRONMENTAL STANDARDS.
1
2
4
4
SAFETY RULES
1. KEEP WORK AREA CLEAN AND WELL LIGHTED.
Poor lighting and cluttered areas invite accidents.
2. MAINTAIN TOOL WITH CARE. Keep tool in good
condition at all times. Keep it clean for best and safest
performance.
3. DON'T OVER-REACH. Keep proper footing and
balance at all times.
4. NEVER OPERATE TOOL WITHOUT CRIMPING DIES
INSTALLED. Ensure connector material is inserted
between dies before compression.
IMPORTANT: Read and understand all of the
instructions and safety information in this manual
before operating or servicing this tool.

GENERAL INFORMATION

3
4
5
1.2
• Manually operated hydraulic compression tool.
• Two stage rapid advance hydraulics.
1.3

SPECIFICATIONS

HYDRAULIC COMPRESSION TOOL:
H-CK 400
Dimensions:
585 mm L
Weight:
6.0 kg
Capacities:
10 - 400 mm
Output:
106 kN
IN ORDER TO OBTAIN WARRANTY SERVICE
YOU MUST REGISTER YOUR PRODUCT BY
LOGGING IN ON www.tnb.com/toolregistration.
FAILURE TO REGISTER YOUR PRODUCT VOIDS
ALL WARRANTIES.

FEATURES

2
TA04930 B Page 2 of 7

Advertisement

loading