Connections - Bosch LHN-UC15L-SIP User Manual

LHN‑UC15L‑SIP | LHN‑UC15W‑SIP | AMN‑P15‑SIP
2
NOTE: To remove the IP Amplifier module, push it downward until the bottom slot disengages
from the rail.
2.2.3

Connections

Once the IP Amplifier module is mounted, you can proceed making the cable connections.
The interior of the IP Amplifier module shows as the reference view bellow.
Reference view
Figure 2.5: Front panel of the IP Amplifier module
Connecting to the network (Figure 2.5, callout 1)
The IP Amplifier module supports PoE/PoE+ power supply mode. You need one Ethernet cable
to connect to a PoE switch for a convenient installation. For the most reliable operation,
always use shielded CAT-5e or higher class cables.
Notice!
i
The IP Amplifier module shall be connected using shielded network cables that are properly
grounded.
Bosch Security Systems B.V.
After the mounting plate is secured
in place, clip the IP Amplifier
module to the DIN rail.
1
2 3 4
User manual
Installation | en
2023.02 | V01 | F.01U.389.835
17