Mitsubishi Electric MAC-SL100M-E Quick Start Manual

JG79N351H01
S
AFETY PRECAUTIONS
CAUTION
Never put batteries in your mouth for any reason to avoid accidental
ingestion.
• Battery ingestion may cause choking and/or poisoning.
Replace all batteries of the remote controller with new ones of the same
type.
• Using an old battery together with a new one may cause overheating, leak-
age, or explosion.
,I WKH EDWWHU\ À XLG FRPHV LQ FRQWDFW ZLWK \RXU VNLQ RU FORWKHV ZDVK WKHP
thoroughly with clean water.
• ,I WKH EDWWHU\ À XLG FRPHV LQ FRQWDFW ZLWK \RXU H\HV ZDVK WKHP WKRURXJKO\
with clean water and immediately seek medical attention.
Incorrect handling could cause serious hazard depending on the conditions.
P
REPARATION BEFORE OPERATION
Remote controller
Operation display section
Signal transmitting section
Distance of signal : About 6 m
Beep(s) is (are) heard from the indoor unit
when the signal is received.
Remote controller holder
• Install the remote controller holder in a
place where the signal can be received by
the indoor unit.
Note:
Selecting installation location:
• Where it is easy to operate and easily visible.
• Where children cannot touch it.
‡ 6HOHFW D SRVLWLRQ DERXW  P DERYH WKH À RRU DQG FKHFN WKDW VLJQDOV IURP
the remote controller are surely received by the indoor unit from that posi-
tion ('beep' or 'beep beep' receiving tone sounds). After that, attach remote
controller holder to a pillar or wall and install wireless remote controller.
‡ ,Q URRPV ZKHUH LQYHUWHU W\SH À XRUHVFHQW ODPSV DUH XVHG WKH VLJQDO IURP WKH
wireless remote controller may not be received.
Before operation:
Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
1.
Remove the back lid.
2.
3.
Install the back lid.
Note:
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with ex-
pired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
Wireless Remote Controller
MAC-SL100M-E
4.
Press RESET.
Insert the negative
pole of AAA alkaline
EDWWHULHV ¿ UVW
EN English is original
D
ISPOSAL
To dispose of this product, consult your dealer.
Note:
This symbol mark is for EU countries only.
This symbol mark is according to the directive 2006/66/
EC Article 20 Information for end-users and Annex II.
Fig. 1
Your MITSUBISHI ELECTRIC product is designed and manufactured with high
quality materials and components which can be recycled and/or reused.
This symbol means that batteries and accumulators, at their end-of-life,
should be disposed of separately from your household waste. If a chemical
symbol is printed beneath the symbol (Fig. 1), this chemical symbol
means that the battery or accumulator contains a heavy metal at a certain
concentration.
This will be indicated as follows: Hg: mercury (0.0005%), Cd: cadmium
(0.002%), Pb: lead (0.004%)
In the European Union there are separate collection systems for used batteries
and accumulators.
Please, dispose of batteries and accumulators correctly at your local
community waste collection/recycling centre.
3OHDVH KHOS XV WR FRQVHUYH WKH HQYLURQPHQW ZH OLYH LQ
S
ELECTING OPERATION MODES
OFF/ON (stop/operate) button
Operation select button
(COOL) (DRY)
HEAT : MSZ only
Temperature buttons
Each press raises or lowers the temperature by 1°C.
FAN speed control button
(AUTO) (Low)
8SGRZQ DLUÀ RZ FRQWURO EXWWRQ
(AUTO) (1) (2)
ECONO COOL button
7KH VHW WHPSHUDWXUH DQG WKH DLUÀ RZ GLUHFWLRQ DUH DXWRPDWL
cally changed by the microprocessor.
TIME, TIMER set button
Press during operation to set the timer.
(OFF TIMER) (ON TIMER)
Press to set the time of timer.
Note : Available functions vary depending on the model.
(HEAT) (FAN)
(Med.) (High) (Super High)
(3) (4) (5) (SWING)
TIMER
RELEASE