Husqvarna AUTOMOWER FlexiFence Operator's Manual page 9

To install the product
1. Put the zone boundary wire around the stay-out zone.
2. Cut the 2 ends of the zone boundary wire.
3. Attach 1 connector to each end of the zone boundary wire.
4. Attach the 2 connectors (A) to the 2 connections on the product (B). (Fig.
10)
5. Use a hammer or a plastic mallet to attach the zone boundary wire with
stakes into the ground. Put the stakes at a maximum of 75 cm / 30 in.
distance from each other.
6. Put the product in the stay-out zone and attach it to the ground with stakes
with a hammer or a plastic mallet.
7. Enable the Zone Generator function of your robotic lawn mower. Refer to
Operator's manual of the robotic lawn mower.
Note:
If the product does not have the Zone Generator menu, a
firmware update of the robotic lawn mower is necessary.
To do a test of the installation
1. Set the product to ON and make sure that the LED indicator is green.
2. Make sure that ECO mode of the robotic lawn mower is disabled. Refer to
ECO Mode in the Operator's Manual for the robotic lawn mower.
3. Put the robotic lawn mower 1-2 m in front of the stay-out zone. Make sure
that the robotic lawn mower points forward to the stay-out zone.
4. Start the robotic lawn mower and make sure that it stops by the zone
boundary wire.
Note:
If there is problems with the installation, refer to
page 11 .
1685 - 004 - 26.10.2022
Troubleshooting on
9