Download Print this page

Panasonic ET-LAD7700 Replacement Instructions

Lamp unit for dlp projector

Advertisement

Quick Links

Read these instructions
completely before replacing
Lamp unit.
Information for Users on Collection and Disposal of Old Equipment and used Batteries
These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products
and batteries should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points,
in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC.
By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative
effects on human health and the environment which could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products and batteries, please contact your local municipality, your
waste disposal service or the point of sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information.
[Information on Disposal in other Countries outside the European Union]
These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or
dealer and ask for the correct method of disposal.
Note for the battery symbol (bottom two symbol examples):
This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the
Directive for the chemical involved.
Cd
Replacement Instructions
Lamp unit for DLP™ Projector Commercial Use
Model No.
Model No.
Replacement Lamp Unit
ET-LAD7700
ET-LAD7700W
Long Life Lamp Unit
ET-LAD7700L
ET-LAD7700LW
(1 pc)
(2 pcs)
(1 pc)
(2 pcs)
TQZH596-6
TQZH 596-4
1

Advertisement

loading

Summary of Contents for Panasonic ET-LAD7700

  • Page 1 Replacement Instructions Lamp unit for DLP™ Projector Commercial Use Replacement Lamp Unit ET-LAD7700 (1 pc) Model No. ET-LAD7700W (2 pcs) Long Life Lamp Unit ET-LAD7700L (1 pc) Model No. ET-LAD7700LW (2 pcs) Read these instructions completely before replacing Lamp unit.
  • Page 2 Precautions with regard to safety Caution The lamp cover will be hot after use. • Burns may result if you touch the lamp cover while it is hot. Notes on replacing the lamp unit • Take extreme care when handling the removed lamp unit, as it contains gas under high pressure and can easily become damaged if it is struck against hard objects or dropped.
  • Page 3 Using a Philips screwdriver, remove the 7 screws on the lamp unit cover located on the rear of the projector. Remove the lamp unit cover. Use a Phillips screwdriver to loosen each of the two lamp unit fixing screws until the screws turn freely. Then hold the handle of the lamp unit and gently pull it out from the projector.
  • Page 4 When more than one lamp has been replaced, ENTER:EXECUTE MENU:ESC repeat the procedure from step 14. Consult the operating instructions to replace the old air filter. Accessory Air filter 1 Printed in Japan https://panasonic.net/cns/projector/ SS0804AM6047 -PS M0804-4059...

This manual is also suitable for:

Et-lad7700wEt-lad7700lEt-lad7700lw