Advertisement
Quick Links
Read these instructions completely before replacing Lamp unit.
Information for Users on Collection and Disposal of Old Equipment and used Batteries
These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic
products and batteries should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection
points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC.
By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential
negative effects on human health and the environment which could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products and batteries, please contact your local municipality,
your waste disposal service or the point of sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information.
[Information on Disposal in other Countries outside the European Union]
These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities
or dealer and ask for the correct method of disposal.
Note for the battery symbol (bottom two symbol examples):
This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the
Directive for the chemical involved.
Cd
NOTICE:
For USA only
Hg -LAMP CONTAINS MERCURY,
Manage in Accord with Disposal Laws,
See: www.lamprecycle.org or 1-888-411-1996
WARNING!
When replacing the lamp, allow it
to cool for at least one hour before
handling it.
Replacement Instructions
Lamp unit for DLP
Model No.
Projector Commercial Use
TM
ET-LAD40
ET-LAD40W
WARNING!
Make sure that two lamp units are
always installed.
(1 pc.)
(2 pcs.)
TQZH920-5
Advertisement
Related Manuals for Panasonic ET-LAD40
Summary of Contents for Panasonic ET-LAD40
- Page 1 Replacement Instructions Lamp unit for DLP Projector Commercial Use ET-LAD40 (1 pc.) Model No. ET-LAD40W (2 pcs.) Read these instructions completely before replacing Lamp unit. Information for Users on Collection and Disposal of Old Equipment and used Batteries These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste.
- Page 2 WARNING! WARNING! Before replacing the lamp, be sure Do not disassemble the lamp unit. to disconnect the power cord plug from the wall outlet. CAUTION! Do not use the old lamp unit. Accessories Air filter : 2 pcs. Precautions on lamp unit replacement Remove the power plug and confirm that the surroundings of the lamp unit have cooled off.
- Page 3 Lamp unit replacement procedures After turning the power off following the Operating Instructions of the projector, remove the power plug and check that the surroundings of the lamp unit have cooled off. Check that the fan has stopped running. Have a Phillips screwdriver ready ahead of time. Remove the screw securing the lamp unit cover, and then slide the lamp unit cover a little toward the left, and remove it.
- Page 4 • Clean the air filter section once every 100 hours or so as a guideline depending on the location of projector operation. • Do not rinse off the air filter with water. Doing so will impair the filter’s ability to provide protection from dust. Web Site : https://panasonic.net/cns/projector/ Printed in Japan SS0507AM5047 -PS...