Dimensional Data - Hitachi ATW-IOT-01 Instruction Manual

DIMENSIONAL DATA

2. Remove the cover from the gateway.
3. Mount the wiring plate to the wall
or wallbox.

NOTE
The plugs and mounting screws required are
supplied.
4. Connect the gateway wiring.
• Connect the H-LINK cable.
• Place the cable through the orifice
identified by marker 3.
• In case of using WI-FI 6 or equivalent,
may be necessary to disable 5GHz
network or to create separate 2.4GHz
network.
• Connect the power cable
(L = Live; N = Neutral) (Tightening
torque 0.50N·m)
• Place the power cable in the cable
guide identified by marker 1.
EN
PMML0635 rev.0 - 01/2023
5. The cables must be positioned in
the box's cable guides in order to
guarantee the pull-off strength.
L N
1~ 230V 50Hz
L
CB
N
(1) Power cable type cannot be lighter than the
specified in 60245 IEC 57.
Item
CB Circuit Breaker 5A
Cable
6. Attach the cover of the gateway to
the wiring plate.
7. Reconnect the mains power to the
system.
8. Download the application from Apple
store or Play store. Application is also
available on www.csnetmanager.com.
4. DIMENSIONAL DATA
98
ATW-IOT-01
H-LINK
YUTAK
YUTAKI
1 2
Termina
Terminal
Board
board
H-LINK
Notes
2 x 0.75
(1)
80,79
2