LG CBEZ2414B Owner's Manual page 12

global_main.book.book Page 12 Monday, January 2, 2023 3:53 PM
INSTALLATION
12
Adjust the bracket position to suit for different
work surface's thickness.
WARNING
• Under any circumstances, make sure that the
brackets cannot come into contact with the inner
surfaces of the worktop after installation.
CAUTION
• The hob must be installed by qualified
technicians. We have technicians available for
such service. Never carry out the installation by
yourself.
• The hob must not be installed directly above a
dishwasher, fridge, freezer, washing machine or
clothes dryer, as the humidity may damage the
hob.
• The hob shall be installed so that better heat
radiation can be ensured to enhance its
reliability.
• The wall and induced heating zone above the
installation surface shall withstand heat.
• A steam cleaner is not to be used.
Connecting the hob to the mains
power supply
This hob must be connected to the mains power
supply only by a qualified electrician.
Before connecting the hob to the mains power
supply, check that:
• The domestic wiring system is suitable for the
power drawn by the hob.
• The voltage corresponds to the value given in
the rating plate.
• The power supply cable sections can withstand
the load specified on the rating plate.
Connect the hob to the mains power supply. Do not
use adapters, reducers, or branching devices, as
they can cause overheating and fire.
The power supply cable must not touch any hot
parts and must be positioned so that its
temperature will not exceed 75 ℃ at any point.
Check with an electrician whether the domestic
wiring system is suitable without alterations.
Any alterations must only be made by a qualified
electrician.
• If the power cord is damaged or needs to be
replaced, contact an LG Electronics Customer
Information Centre.
• The installer must ensure that the correct
electrical connection has been made and that it
is compliant with safety regulations.
• If the appliance is being connected directly to the
mains an omnipolar circuit-breaker must be
installed with a minimum opening of 3 mm
between contacts.
• The power cord must not be bent or
compressed.
• The power cord must be checked regularly and
replaced by authorised technicians only.
WARNING
• Make sure that the bottom surface and the
power cord of the hob do not come into contact.