Using A Memory Card - Epson P-2000 Basic Manual

Avoid using outlets on the same circuit as photocopiers or air
control systems that regularly switch on and off.
Position this product's power cord so that it will not be stepped on
or run over.
Do not place any objects on the power cord and the AC adapter.
Keep the power cord straight at the ends and at the points where it
enters the transformer.
The power cord should be placed to avoid abrasions, cuts, fraying,
crimping, kinking, and other damage.
If you cannot insert the plug into the power outlet, contact an
electrician.
Remove the AC plug from the outlet during lightning storms.
For US and Canadian users: Use the included power cord or a 6 to
10 foot UL-approved type SPT-2 or heavier type, 2
cord with a 125 V 10 A plug and 125 V 7 A connector.

Using a Memory Card

Only memory cards designed for the product's specifications can
be used. (See page 17.)
The methods for using memory cards vary according to card type.
See the documentation included with your memory card for
details.
Do not remove a memory card or turn off the product while the
light is flashing.
Access
Using the LCD
The LCD panel on this product may contain a few small bright or
dark spots. These are normal and do not mean that your LCD
panel is damaged in any way.
If the LCD panel on this product is damaged, contact Epson.
If the liquid crystal solution contained in the LCD panel on this
product leaks out and gets onto your hands, wash them
thoroughly with soap and water. If it gets into your eyes, flush
x
18 AWG
57