Advertisement
S
F
P E C
I L E
Wall Mount Bracket
The dimensional relationship between the screen and projector is shown below.
Determine the installation position on the wall based on the "Dimensional relationship diagram" and the
"Dimensional relationship".
The projected image size can be adjusted by changing the distance between the screen and the projector.
Dimensional relationship diagram
<For PT-CMZ50>
→
Center axis of
horizontal swing
adjustment
L
Note
• The illustrations of projectors in this manual are for informational purposes only. The appearance may differ from the actual product.
• This drawing is not in exact scale.
SH
Projected image height
SW
Projected image width
SD
Projected image size
L
Projection distance (distance from the screen surface to the mirror reflection surface
D
Distance from the wall surface to the screen surface
L1
Distance from the screen surface to the back surface of the projector
L2
Distance from the back surface of the projector to the wall surface
L3
Distance (225 mm [8-27/32 in]) from the center axis of horizontal swing adjustment to the back surface of the projector
L4
Distance from the wall surface to the center axis of horizontal swing adjustment
L5
Distance (47.5 mm [1-7/8 in]) from the image center to the wall mount bracket center
Distance from the top edge of the projected image to the center of screw holes (on the lower side) used for securing the wall mount
H1
bracket
Distance from the top edge of the projected image to the center of screw holes (on the upper side) used for securing the wall mount
H2
bracket
1 The mirror reflection surface cannot be seen from the outside because it is located inside the projector.
Attention
• To prevent obstruction of the intake and exhaust vents, install the projector with a clearance from walls and objects. For details about the
required distance from surrounding walls and objects, refer to the operating instructions for your projector. If you are installing the projector
in a sealed space, be sure to provide additional air conditioning equipment and ventilation equipment. Insufficient ventilation will result in an
accumulation of heat and may activate the projector's protection circuit.
• Avoid setting up in places which are subject to sudden temperature changes, such as near an air conditioner or lighting equipment (studio
lamps, etc.).
As of February 2023
WBC100/PKC300BG_STR_T01_14/02/2023
ET-WBC100/ET-PKC300B
L4
Wall mount bracket center →
L3
L2
L1
SH
SH
D
H1
L5
SD
←
Image center
SW
1
)
TENTATIVE
H2
7/9
Advertisement
