Setting Up The Repeater - Asus RP-AC66 Quick Start Manual

Setting up the Repeater

Turning the Repeater on
1. Place RP-AC66 near your router/AP.
2. Plug RP-AC66 to a power outlet, wait for one (1) minute until
the Power LED becomes solid green.
Connecting to a network
Select one of the following ways to connect the Repeater to a
network.
Option A: Connecting through GUI
1. Use a Wi-Fi enabled device, such as your desktop PC/note-
book/tablet, to find and connect to ASUS_RPAC66 / ASUS_
RPAC66_5G wireless network.
2. Launch a web browser and enter http://repeater.asus.com in
the address bar to access the Repeater.
3. Enter the default login name and password, which are admin/
admin.
4. Follow the Quick Internet Setup steps below to set up the
Repeater:
4
U10858_RP-AC66_QSG.indb 4
• Connect to a Wi-Fi network and when prompted, enter the
security key. If your Wi-Fi network is hidden, click Manual
setting.
• You can either tick "Use default setting" or enter the SSID
and security key/password for your extended network. When
done, click Next.
NOTE: The Repeater's wireless network name (SSID) changes to
your existing Wi-Fi network name, ending with _RPT or _RPT5G
and shares your router/AP's Wireless Password.
• Connect your wireless devices to the new repeater network.
Option B: Using WPS (Wi-Fi Protected Setup)
1. Press the WPS button on the router/AP.
2. Press the WPS button on the front cover of RP-AC66 for more
than two (2) seconds, until the LEDs start to blink.
NOTE: Refer to the router's manual for the location of the WPS
button.
2015-09-24 9:41:10