Setting Interpolation Processing; Setting Resizer Effects - Sony MLS-X1 User Manual

Setting a CG border
The image to embed in the border and the key signal for
keying the image are selected on key 1. The border image
and the key signal for the image are selected on key 2.
1
Open the Home > M/E-1 > Key1 > Resizer/Proc Key
> Resizer Adjust/DME Select menu (11101.41).
2
Set the [Resizer] button to the on state.
3
Set the [CG Border] button in the [CG Border] group
to the on state and set the following parameters.
No. Parameter
1 Location X
2 Location Y
3 Size
To lock the CG border setting
You can lock the position and size of the border image of
the CG border.
To lock the CG border setting, set the [Frame Pos Lock]
button in the [CG Border] group to the on state.
Note
Locking the CG border setting sets all resizer parameters
to the default values, and the settings cannot be changed.

Setting Interpolation Processing

You can set the number of pixels and the anti-aliasing
mode used for interpolation processing.
1
Open the Home > M/E-1 > Key1 > Resizer/Proc Key
> Resizer Process menu (11101.43).
2
Set the [Resizer] button to the on state.
3
In the [Interpolation Mode] group, set the number of
pixels to use in interpolation.
Multi: Use multi-point interpolation.
Linear: Use two-point interpolation.
4
In the [Filter Mode] group, select an anti-aliasing
mode.
Adjustment
Horizontal position
Vertical position
Size
Mode1: Even when the picture is reduced, add
compensation so that it can be seen clearly
(standard).
Mode2: Suppress aliasing when enlarging or
reducing the picture (soft).
Mode3: Do not suppress aliasing when enlarging or
reducing the picture (sharp).

Setting Resizer Effects

Setting a wide key border
1
Open the Home > M/E-1 > Key1 > Resizer/Proc Key
> Enhanced Effect menu (11101.42).
2
Set the [Resizer] button to the on state.
3
Set the [Dual Rszr Effect] button to the on state.
4
Set the [Wide Key Border] button to the on state and
set the following parameters.
No. Parameter
1 H
2 V
3 All
4 Soft
5 Density
a) Common to the [Soft] drop shadow parameter.
5
Set the [Border Color] button to the on state and set
the following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
To add an outline to a wide key border
Set the [Outline] button to the on state.
Setting a drop shadow
1
Open the Home > M/E-1 > Key1 > Resizer/Proc Key
> Enhanced Effect menu (11101.42).
2
Set the [Resizer] button to the on state.
143
Adjustment
Simultaneous adjustment of
border width of left and right
edges
Simultaneous adjustment of
border width of top and
bottom edges
Simultaneous adjustment of
border width of top, bottom,
left, and right edges
a)
Softness of border
Density of border
Adjustment
Luminance
Saturation
Hue