Suppl Ying The Power; Charging The Battery - JVC GV-HT1 Instructions Manual

18
EN
Cha rging the ba ttery
Use the provided AA-V68 AC adapter/Charger for charging the battery. Batteries that have not
been completely depleted can also be charged.
1
To AC outlet
Charge
indicator 1
Power lamp
Charge indicator 2
(Blinks during charging → Lights continuously when charging completes.)
Place side with
and symbols
face down.
• Approximate charge time
• Charging not possible
• Number of prints per battery charge → 40 pri nts for each BN -V607 battery (at room
:
N O TES
• If you connect the DC cord to the AC adapter during battery charging, power is supplied to the printer
and charging stops.
• When charging the Battery for the first time or after a long storage period, the Charger Indicator may not
light. In this case, remove the Battery from the AC Power Adapter then try charging again.
• Since the AC Power Adapter processes electricity internally, it becomes warm during use. Be sure to use
it only in well-ventilated areas.
• If the battery operation time remains extremely short even after having been fully charged, the battery is
worn out and needs to be replaced. Please purchase a new one.
Downloaded from:
Battery BN -V607
2
D C output terminal
https://www.usersmanualguide.com/

SUPPL YING THE POWER

Power cord
AC Adapter/ Charger
AA-V68
CO N N ECT AC ADAPTER/ CHARGER
1
• Connect the power cord to a wall outlet.
IN SERT THE BATTERY
2
• The charge indicator starts to blink.
• Charging has completed when the indicator
stops blinking and is on continuously.
REM O VE THE BATTERY
3
• Remove the power cord.
→ Approx. 90 min for each BN-V607 battery
→ Chargi ng i s not possi bl e when the D C cord i s
connected to the AC adapter.
temperature)
3