Philips Lumea SC1994 Manual page 16

16
English
C Treatment
IMPORTANT: First finish sections A (Remove hair & clean your skin) and B (Test
skin 24 hours before treatment) before starting treatment.
1 Connect the power adapter to the device and plug into a power outlet.
2 Press the on/off button
3 Choose the setting you selected after the skin test (section B, step 9).
4 Press the device firmly onto your skin and hold it in place. The 'READY to
flash' light should light up white.
5 Press the flash button to release a flash on your skin. The flash treats the skin
in that spot. The device makes a soft popping sound. The flash gives you a
warm sensation.
After each flash, it takes up to 3.5 seconds until the device is ready to flash
again. You can release a flash when the 'READY to flash' light lights up white.
6 Move to an adjacent spot and press the flash button again. The surface of the
attachment that is in contact with your skin is slightly larger than the light exit
window. The surface of the attachment should overlap the previous spot to
make sure you flash the complete skin area.
DO NOT flash the same spot multiple times during a treatment. The surface
of the attachment should overlap the previous spot to make sure you flash
the complete skin area, but treating the same area multiple times does not
increase efficacy.
to turn on the device.