Haier GE NF80US Installation Instructions Manual page 7

Warm air gas furnace
Hide thumbs Also See for GE NF80US:
Table of Contents

Advertisement

NOTE: The inlet and outlet air openings shall each have a free
area of at least one square inch per 4,000 Btu (645 mm² per
1.17 kW) per hour of the total input rating of all equipment in the
enclosure.
Figure 4. Equipment in Confined Space - All Air from
(All Air through Ventilated Attic)
NOTE: Each air duct opening shall have a free area of at least one
square inch per 2,000 Btu (645 mm² per .59 kW) per hour of the
total input rating of all equipment in the enclosure. If the equipment
room is located against an outside wall and the air openings
communicate directly with the outdoors, each opening shall have
a free area of at least 1 square inch per 4,000 Btu (645 mm² per
1.17 kW) per hour of the total input rating of all other equipment in
the enclosure.
Figure 5. Equipment in Confined Space - All Air from
507330-03G / 31-5000662
Outside
Outside
Setting Equipment
Do not install the furnace on its front or its back. Do not
connect the return air ducts to the back of the furnace.
Doing so will adversely affect the operation of the safety
control devices, which could result in personal injury or
death.
The gas furnace can be installed as shipped in either the
upflow position or the horizontal position.
Select a location that allows for the required clearances
that are listed on the unit nameplate. Also consider gas
supply connections, electrical supply, vent connection, and
installation and service clearances [24 inches (610 mm) at
unit front]. The unit must be level.
NOTE: Units with 1/2 hp and 3/4 hp blower motors are
equipped with three flexible legs and one rigid leg. See
Figure 6. The rigid leg is equipped with a shipping bolt and
a flat white plastic washer (rather than the rubber mounting
grommet used with a flexible mounting leg). The bolt and
washer must be removed before the furnace is placed into
operation. After the bolt and washer have been removed,
the rigid leg will not touch the blower housing.
Issue 2209
WARNING
Units with 1/2 HP & 3/4 HP
Blower Motor.
Figure 6.
Page 7 of 36

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ge nf80ls

Table of Contents