AEG NSC7G181DS User Manual page 12

12 www.aeg.com
If you do not press any
button, the sound switches
off automatically after
around one hour to avoid
disturbing.
4.12 Air filter change
indicator
When the air filter has expired and
requires replacement, the Air filter
change indicator and the Filter Reset
alarm indicator turn on.
Refer to "Installing and replacing the
CleanAir+ filter" section in "Care and
cleaning" chapter for the replacement
instructions.
After the filter replacement, press the
Filter Reset alarm button to turn off the
alarm.
4.13 Setting mode
The Setting mode allows you to:
• Enable or disable the ECOMETER
indicator
• Enable or disable the button sounds
• Change the temperature units from °C
to °F
• Reset the control panel to factory
settings
Activating the Setting mode
To activate the Setting mode:
1. Press and hold the ECO button for
approximately 3 seconds. When the
Setting mode is being activated, the
display shows a blinking
2. Once the Setting mode is switched
on, the display shows
To deactivate the Setting mode, press
and hold the ECO button for
approximately 3 seconds.
The Setting mode deactivates
automatically if you do not interact with
the control panel for 60 seconds.
Navigating the Setting mode
1. Activate the Setting mode (refer to
"Activating the Setting mode").
The display shows
2. Tap the fridge temperature button (on
the left) to change the parameter.
Tap the freezer temperature button
(on the right) to change the
parameter value.
Display
ECOMETER indicator
In order to switch the ECOMETER on or
off:
1. Activate the Setting mode (refer to
"Activating the Setting mode").
The display shows
2. Tap
show respectively
or
indicator.
3. Press and hold the ECO button for
approximately 3 seconds to exit the
Setting mode.
Button sounds
You can enable or disable the button
sounds in the Setting mode. To enable or
disable the sounds:
.
1. Activate the Setting mode (refer to
"Activating the Setting mode").
.
The display shows
2. Tap
Tap
on or off. The indicator will change to
disabled sounds.
3. Press and hold the ECO button for
approximately 3 seconds to exit the
Setting mode.
Temperature units
.
Using the Setting mode, you can change
the temperature unit displayed on the
Default parame‐
ters
ECOMETER indica‐
tor
Button sounds
Temperature units
Factory settings
repeatedly. The indicator will
for the enabled
for the disabled ECOMETER
repeatedly until you see
to switch the sounds either
for the enabled or
.
.
.
for the