Table of Contents
Advertisement
the router software.
2 - Select Connect to make the connection.
3 - A message will be shown when the connection is
successful.
Problems
Wireless network not found or distorted
• Microwave ovens, DECT phones or other Wi-Fi
802.11b/g/n/ac devices in your proximity might
disturb the wireless network.
• Make sure that the firewalls in your network allow
access to the TV's wireless connection.
• If the wireless network does not work properly in
your home, try the wired network installation.
Internet does not work
• If the connection to the router is OK, check the
router connection to the Internet.
The PC and Internet connection are slow
• Look in your wireless router's user manual for
information on indoor range, transfer rate and other
factors of signal quality.
• Use a high-speed (broadband) Internet connection
for your router.
DHCP
• If the connection fails, you can check the DHCP
(Dynamic Host Configuration Protocol) setting of the
router. DHCP should be switched on.
Wired Connection
What You Need
To connect the TV to the Internet, you need a
network router with a connection to the
Internet. Use a high-speed (broadband) connection
to the Internet.
Make the Connection
Make the Connection - WIRED
Press / Home > Settings > Wireless
and Networks > Connect to Network > WIRED.
1 - Connect the router to the TV with a network cable
(Ethernet cable**).
2 - Make sure that the router is switched on.
3 - The TV constantly searches for the network
connection.
4 - A message will be shown when the connection is
successful.
If the connection fails, you can check the DHCP
setting of the router. DHCP should be switched on.
**To fulfill EMC regulations, use a shielded FTP Cat.
5E Ethernet cable.
Settings
View Network Settings
Press / Home > Settings > Wireless
and Networks > Settings > View Network Settings.
You can view all current network settings here. The IP
and MAC address, signal strength, speed, encryption
method, etc.
Network Configuration - DHCP / Static IP
Press / Home > Settings > Wireless
and Networks > Settings > Network Configuration >
DHCP / Static IP .
Select DHCP or, if you are an advanced user, you can
setup your network with static IP addressing.
Network Configuration - Static IP Configuration
Press / Home > Settings > Wireless
and Networks > Settings > Static IP Configuration.
1 - Select Static IP Configuration and configure the
connection.
2 - You can set the number for IP
Address, Netmask, Gateway, DNS 1, or DNS 2.
Wake on LAN (WoL)
Press / Home > Settings > Wireless
and Networks > Settings > Wake on LAN (WoL).
Disable/Enable Wake on LAN (WoL). You may wake
up TV using an external device on the same LAN.
Wake on Wi-Fi (WoWLAN)
Press / Home > Settings > Wireless
and Networks > Settings > Wake on Wi-Fi
(WoWLAN).
Disable/Enable Wake on Wi-Fi (WoWLAN). You may
wake up TV using an external device on the same Wi-
Fi.
Network Type
Press / Home > Settings > Wireless
and Networks > Settings > Network Type.
• Wired - Connecting to a wired network.
• Wireless - In the list of found networks, select on
34
Advertisement
Table of Contents
