AEG PROSTEAM 7000 LF7E7431BI User Manual page 21

Table of Contents

Advertisement

7.6 Prewash
With this option you can add a prewash
phase to a washing programme.
The corresponding indicator above the
touch button illuminates.
• Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust, mud and other
solid particles.
The options can increase the
programme duration.
7.7 Permanent Anti-stain
This option adds an anti-stain phase to
the programme. Use this option for
laundry with hard stains to remove.
To activate/deactivate this option, hold
the Prewash button pressed for 3
seconds until the indicator
goes off on the display.
Pour the stain remover into compartment
.
This option increases the
programme duration.
This option is not available
with a temperature lower
than 40 °C.
7.8 Permanent Soft Plus
Set this option to optimise the fabric
softener distribution and improve fabric
softness.
Recommended when you use fabric
softener.
This option increases the
programme duration.
The corresponding indicator above the
touch button illuminates and also stays
permanently on during next cycles until
this option is deactivated.
7.9 Permanent Extra Rinse
With this option you can permanently
have an extra rinse when you set a new
programme.
To activate/deactivate this option, hold
the Soft Plus button pressed for 3
seconds until the indicator
goes off on the display.
When it is activated, the appliance will
default to this option after you switch it
off or change/reset the programme.
7.10 Plus Steam
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric
creasing and facilitates the fabric ironing.
comes on/
The corresponding indicator above the
touch button illuminates.
The indicator
steam phase.
When the programme stops the display
shows
and the indicator
led are steady on. The drum performs
smooth movements for about 30 minutes
to keep the steam benefit. By touching
any button the anti-crease movements
stop and the door unlocks, the appliance
proposes again the previous set
programme.
To interrupt the anti-crease phase, you
can also:
• Press the On/Off button for a few
seconds to activate or the deactivate
the appliance.
• Turning the programme dial in
another position.
This option increases the
programme duration.
is steady on during
This option can increase the
programme duration.
, the indicator
and the Start/Pause
A small laundry load helps to
reach better results.
ENGLISH
21
comes on/
goes off

Advertisement

Table of Contents
loading

Table of Contents