Table of Contents
Advertisement
6 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
6.1 Setting an operating mode
Your appliance is set to air extraction mode by default.
Note: When using it in circulating-air mode, you require
additional accessories.
7 Basic operation
7.1 Switching on the appliance
Press
.
▶
a The appliance starts at fan setting 2.
7.2 Switching off the appliance
Press
.
▶
7.3 Setting a fan setting
To set a higher fan setting, turn the control ring
1.
clockwise.
To set a lower fan setting, turn the control ring anti-
2.
clockwise.
a The selected fan setting appears on the display.
7.4 Switching on intensive mode
If particularly strong odours or vapours develop, you
can use intensive mode.
To switch on intensive mode 1, turn the control ring
1.
clockwise until
appears on the display.
To switch on intensive mode 2, turn the control ring
2.
clockwise until appears on the display.
a After approx. 6 minutes, the appliance automatically
switches to fan setting 3.
7.5 Switching off intensive mode
Turn the control ring anti-clockwise.
▶
7.6 Switching on the fan run-on
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
Press
.
▶
a The remaining fan run-on time appears on the dis-
play.
a The fan run-on starts at fan setting 1.
a The appliance switches off automatically after ap-
prox. 10 minutes.
1
Depending on the appliance specifications
Before using for the first time en
When using it in circulating-air mode, set the operat-
▶
ing mode.
7.7 Setting the run-on time
You can set a run-on time of between 1 and
99 minutes.
To extend the run-on time, turn the control ring
1.
clockwise
2.
To reduce the run-on time, turn the control ring anti-
clockwise.
7.8 Switching off the fan run-on
Press
.
▶
a The appliance starts at the previously selected fan
setting.
7.9 Switching on automatic mode
The optimum fan setting is set automatically using a
sensor.
Press .
▶
7.10 Switching off automatic mode
Press .
▶
a The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
a Automatic mode runs for a maximum of four hours.
7.11 Sensor sensitivity
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡ Factory setting: 6
¡ Lowest setting: 1
¡ Highest setting: 10
7.12 Setting the sensor sensitivity
Requirement: The appliance is switched off.
Press and hold .
1.
a The setting is displayed after approx. one second.
Use the control ring to select the setting.
2.
1
1
7
Advertisement
Table of Contents
